Chimera Engineering 4.5 inch Billet Rear Lowering Link - Honda Grom 125 (ALL Years)

Looking to lower the rear of your Honda GROM a bit to go with the lower front end? Here you go! Chimera 4.5" rear lowering link kit requires no drilling and can be installed with the bike on the ground when it's properly supported (because you have to remove the rear shock). You do not need to remove the chain/wheel/etc to install if you are not using a stretch.

The stock rear 'hugger' fender can still be used, but will require trimming around the lowering link to fit!

*PLEASE READ: Anything more than 2.5" Lowering would require a stretch kit. This 4.5" lowering link would require a stretch kit. It may also require modifying or a shorter kickstand leg as well!

**IMPORTANT: Actual lowering height will vary... The added length of a stretch will cause the swingarm/axle height in relation to the frame to move further than the stock length swingarm when lowered. With the extended swingarm, it is closer to 3.75-4" of lowering, depending on the length of stretch you choose to extend to.