MODIFIED (6 BOLT) GENUINE HONDA OEM CLUTCH PRESSURE PLATE - HONDA GROM 125

MODIFIED (6 BOLT) GENUINE HONDA OEM CLUTCH PRESSURE PLATE - HONDA GROM 125 and Monkey. The OEM pressure plate is made from cast aluminum, which is very easy to break or damage. Don't risk damaging or breaking the pressure plate tabs by tapping the threads yourself, these are CNC drilled and tapped for a perfect fitment. See below for installation tips.

Includes 3x Bolts.

This modified clutch pressure plate would require an aftermarket clutch lifter plate with 6 holes. It would work perfectly with Chimera V2 CNC Lifter Plate

You will need to reuse your existing 3 old bolts!

Kit includes the required 3 additional bolts. The product photos show 6 bolts for reference only.

Installation tip:

These OEM clutch parts are made from a low-pressure cast aluminum process, which means that these parts are very brittle. This is the reason why the CNC clutch lifter plate was created because the tabs on the lifter plates would crack once a set of stiffer clutch springs are installed. The same brittleness would apply to the pressure plate as well, please make sure that you tighten down the bolts in a star pattern evenly and torque it in increments. Do not just one shot torque the bolts to 12n/mm! Also, make sure that the lifter plate is seated correctly once the lifter plate is about to make contact with the pressure plate before torqueing the bolts. If the tab breaks during installation, it's not covered under any replacement or warranty as Honda doesn't warranty replacement parts and most likely the breakage was due to an installation error. Take your time to install this part.